Re: [ecasound] control a parameter on commandline

From: Antonio P. P. Almeida <perusio@email-addr-hidden>
Date: Mon Jun 14 2010 - 19:27:36 EEST

On 14 Jun 2010 15h54 WEST, wrote:

> I am trying to figure out if it is possible to control a plugin
> parameter on the commandline. I have the following command:
> ecasound -el:delay_60s,1,1 -i alsahw,0,0 -o alsahw,1,0

AFAIK, you cannot do that with the command line. You can however do
that using the interactive mode.

You enter the interactive mode by issuing ecasound -c

See the ecasound-iam man page. In particular the cop-set command, it
         cop-set ˘chainop_id,param_id,value˘
               Changes the value of a single chain operator
               parameter. Unlike other chain operator commands, this
               can also be used during processing. See also
--- appa

ThinkGeek and WIRED's GeekDad team up for the Ultimate
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the
lucky parental unit. See the prize list and enter to win:
Ecasound-list mailing list
Received on Mon Jun 14 20:15:04 2010

This archive was generated by hypermail 2.1.8 : Mon Jun 14 2010 - 20:15:04 EEST