Subject: Re: [ecasound] copying one signal to two channels?
From: Kai Vehmanen (email@example.com)
Date: Sun Nov 26 2000 - 22:21:52 EET
On Sat, 25 Nov 2000, Krzys Majewski wrote:
> Suppose I have a stereo line in, but only the left channel has a
> signal. How can I route this signal to both left and right output channels?
> ecasound -a:1,2 -i /dev/dsp -o /dev/dsp -erc:1,2
Hmm, that should definitely work. Try recording to a separate file,
and see if you get the same behaviour.
# note -a:1 is enough, assigned to two chains is not needed
ecasound -f:16,2,44100 -a:1 -i /dev/dsp -o file.wav -erc:1,2
Then check the balance, preferably without using /dev/dsp. For instance:
ecasound -i file.wav -o null -ev
... if the right channel is still silent, there's a bug somewhere.
-- . http://www.eca.cx ... [ audio software for linux ] /\ . . http://www.eca.cx/aivastus ... [ aivastus net radio ] /\ .
-- To unsubscribe send message 'unsubscribe' in the body of the message to <firstname.lastname@example.org>.
This archive was generated by hypermail 2b28 : Sun Nov 26 2000 - 21:47:48 EET