Subject: Re: [ecasound] 1.7.0d11: problems adding effects
From: Kai Vehmanen (email@example.com)
Date: Sun Feb 20 2000 - 16:26:57 EET
On Thu, 17 Feb 2000, Jeremy Hall wrote:
> I built 1.7.0d11 and started it with a cs-load to get some settings going,
> then I did a t to start. That worked out fine, then I did a -etf:10
> When I did this, ecasound reconnected the setup but no sound was
> produced. I did a t to make it start and got a segmentation fault.
Hmm, I've tried a few times to reproduce this behaviour, but with no
luck. Does the same happen, if you replace all sound card devices with
> sounds like possibly a libraries conflict. also a make install tried to
> build qtecasound despite --disable-qt
Hmm, this is odd. I'll check the autoconf scripts.
-- Kai Vehmanen <firstname.lastname@example.org> -------- CS, University of Turku, Finland . http://www.wakkanet.fi/ecasound/ - linux multitrack audio processing . http://www.wakkanet.fi/sculpscape/ - ambient-idm-rock-... mp3/ra/wav
This archive was generated by hypermail 2a24 : Sun Feb 20 2000 - 15:37:26 EET